Photoelectric sensors | ||||||||||||||||||||||||||||||||||||
|
|
|||||||||||||||||||||||||||||||||||
Features | |||
![]() |
Sensor/detection principle: | Photoelectric retro-reflective sensor | ![]() |
![]() |
Dimensions (W x H x D): | 11 mm x 31 mm x 20 mm | ![]() |
![]() |
Housing design (light emission): | Rectangular | ![]() |
![]() |
Sensing range max.: | 0.01 m ... 7.2 m1) | ![]() |
![]() |
Sensing range: | 0.01 m ... 5.5 m2) | ![]() |
![]() |
Type of light: | Visible red light | ![]() |
![]() |
Light source: | LED3) | ![]() |
![]() |
Wave length: | 632 nm | ![]() |
![]() |
Adjustment: | Potentiometer | ![]() |
![]() |
Light spot size (distance): | ? 280 mm (4 m) | ![]() |
![]() |
1)2)PL80A3)Average service life of 100,000 h at TA= +25 °C | ![]() |
Mechanics/electronics | |||
![]() |
Supply voltage: | 10 V DC ... 30 V DC1) | ![]() |
![]() |
Residual ripple: | ± 10 %2) | ![]() |
![]() |
Power consumption: | ≤ 30 mA3) | ![]() |
![]() |
Output type: | NPN | ![]() |
![]() |
Switching mode: | Light/dark switching | ![]() |
![]() |
Switching mode selector: | Selectable via light/dark rotary switch | ![]() |
![]() |
Output current Imax.: | 100 mA | ![]() |
![]() |
Response time: | ≤ 0.5 ms4) | ![]() |
![]() |
Switching frequency: | 1,000 Hz5) | ![]() |
![]() |
Connection type: | Connector M8, 4-pin | ![]() |
![]() |
Circuit protection: | A, B, D6)7)8) | ![]() |
![]() |
Protection class: | III | ![]() |
![]() |
Polarisation filter: | ![]() |
![]() |
![]() |
Special device: | - | ![]() |
![]() |
Optics material: | PMMA | ![]() |
![]() |
Enclosure rating: | IP 67 | ![]() |
![]() |
Items supplied: | Mounting bracket BEF-W100-A, Reflector P250 | ![]() |
![]() |
Ambient operating temperature: | -25 °C ... +55 °C | ![]() |
![]() |
Ambient storage temperature: | -40 °C ... +70 °C | ![]() |
![]() |
Signal voltage NPN HIGH/LOW: | Approx. VS / < 1.8 V | ![]() |
![]() |
Housing material: | ABS/PC/POM, Plastic | ![]() |
![]() |
1)Limit values2)May not exceed or fall short of VStolerances3)Without load4)Signal transit time with resistive load5)With light/dark ratio 1:16)A = VSconnections reverse-polarity protected7)B = output reverse-polarity protected8)D = outputs overcurrent and short-circuit protected |