6026031 WS/WE100-N3230

Photoelectric sensors
W100, Through-beam photoelectric sensor Type WS/WE100-N3230 Part No. 6026031 At a glance Standard miniature housing with M3 threaded mounting holes Optics with standard red LED or bright light LED Connector and cable versions Light/dark switching and sensitivity adjustment via rotary switch possible Various versions are available, including through-beam, retro-reflective, energetic and background suppression Wide variety of accessories available Your benefits Highly visible light spot simplifies alignment Reliable detection of glossy objects at a close range with WL100 bright light models Less contamination due to high optical operating reserve M3 threaded mounting holes provide quick and easy installation Product will be phased out and can be ordered until 31.12.2015.

Features
	Sensor/detection principle:	Through-beam photoelectric sensor
	Dimensions (W x H x D):	11 mm x 31 mm x 20 mm
	Housing design (light emission):	Rectangular
	Sensing range max.:	0 m ... 15 m
	Sensing range:	0 m ... 12 m
	Type of light:	Visible red light
	Light source:	LED1)
	Wave length:	680 nm
	Angle of dispersion:	Ca. 7.2 °
	Focus adjustable:	-
	Light spot size (distance):	? 1,500 mm (12 m)

1)Average service life of 100,000 h at TA= +25 °C

Mechanics/electronics
	Supply voltage:	10 V DC ... 30 V DC1)
	Residual ripple:	± 10 %2)
	Power consumption, sender:	≤ 15 mA3)
	Power consumption, receiver:	≤ 20 mA4)
	Output type:	NPN, open collector
	Switching mode:	Dark switching
	Output current Imax.:	≤ 100 mA
	Response time:	≤ 0.5 ms5)
	Switching frequency:	1,000 Hz6)
	Angle of reception:	Ca. 15 °
	Connection type:	Connector M8, 3-pin
	Circuit protection:	A, B, D7)8)9)
	Weight:	18 g
	Polarisation filter:	-
	Special device:	-
	Optics material:	PMMA
	Enclosure rating:	IP 65
	Ambient operating temperature:	-25 °C ... +55 °C
	Ambient storage temperature:	-40 °C ... +70 °C
	Signal voltage NPN HIGH/LOW:	Approx. VS / < 1.8 V
	Housing material:	ABS/PC, Plastic

1)Limit values, operation in short-circuit protected network max. 8 A2)May not exceed or fall short of VStolerances3)4)Without load5)Signal transit time with resistive load6)With light/dark ratio 1:17)A = VSconnections reverse-polarity protected8)B = inputs and output reverse-polarity protected9)D = outputs overcurrent and short-circuit protected